How to Hang a Perfect Grid of Picture Frames
How We Learned to Plan a Gallery Wall the Right Way
We love a good plan—because without one you can end up with unnecessary holes in the wall. Case in point: the frame arrangement we just installed above our sectional.
The idea was simple. We wanted to fill the large empty space above Karl with a bold grid of oversized frames. Inspired by a smaller frame grid we’d once hung in our old den, we planned to use 20.5 x 20.5″ Ribba frames from Ikea for a greater visual impact (we already own and like four of them, and they’re inexpensive).

After some quick measuring and holding a couple of frames up to the wall, we decided that six frames—two rows of three—would be the right size to fill the center portion of the wall, leaving room on either side for lamps on a long console we plan to build behind the sectional. (For the record, we’d moved a smaller area rug into the guest room for visiting in-laws and temporarily returned it to the living room until we decide on a larger rug.)

We bought six new Ribba frames at Ikea—better to match than to mix new and old, since colors can vary—and came home ready to hang them. To avoid mistakes, we planned to tape paper from the frames to the wall first. The backing paper that comes with each frame is almost the perfect size to mock up a layout.

This is where we slipped up. We taped up two sheets to test height, which is useful, but when Sherry suggested we tape up all six to check the full composition I brushed it off. Maybe I was eager to start drilling. Maybe I figured the five or six would look fine. Either way, I told her it would be okay and started making holes.
After measuring, marking, and double-checking, I had five of the six frames up when Sherry pointed out the obvious: the arrangement was too small. It needed eight frames, not six. The five felt too airy and didn’t create the strong, centered look we wanted above the sectional.
(I wish I’d photographed the awkward result, but I was too annoyed with myself to take a picture.)
Lesson learned: tape everything first. If we had mock‑uped all eight positions with paper, there would have been no wasted time or extra holes. Instead we had to take down five frames, remove ten screws, re-calculate spacing so eight frames would be properly centered on the wall and aligned with the ceiling beam, then drill and install an additional sixteen screws. On the plus side, we had two of our original Ribba frames that matched the new ones, so we avoided another trip to Ikea and were able to complete the eight-frame layout.

All eight frames look much better. The composition now fills the wall properly and will balance nicely once we build the long console and add table lamps on either side.

We’re still deciding what to put inside the frames—family photos for a warm, personal touch, or something more graphic to make a bold statement. Either way, the hanging part is finished, even if it taught us humility. The mistake only cost time, energy, and a few extra wall patches—no major cash outlay—so it’s an expensive lesson only in patience and planning. Speaking of patching, there are still a couple of pencil marks and holes from the first attempt that need fixing. Sherry has kindly volunteered to handle that.

Have you ever rushed a gallery wall or frame arrangement and regretted it? We’d love to hear your stories and tips—especially the planning tricks you’d recommend to avoid extra holes and rework. Bad planners unite: next time we’ll tape every sheet of paper first.
P.S. If you’re rotating kids’ art or frequently swapped prints, there are frames that make changing the display easier without removing the frame from the wall—useful for busy households.








