Objectales

Popular

DIY Custom Wood Frames for Large Art and Posters

featured 54861

This is my favorite project so far: framed bike art that turned out better than I imagined. I’m thrilled not only with the final look but also with how simple and inexpensive it was to make. The whole project cost about $14 for lumber and required only basic tools and a bit of patience while the stain dried.

img 54861 1

Before, the posters were taped to the wall like temporary retail displays — not very inspiring. Once they were framed, the difference was night and day. Framing gave the artwork presence and a finished, intentional feel.

img 54861 2

img 54861 3

The supplies were straightforward: four 6-foot 1×2 pine boards from Home Depot. Because we were building two frames, we cut the boards so each frame had two long sides and two shorter top/bottom pieces. To keep the cuts consistent, I clamped four boards together and cut them in pairs. If you don’t own a saw, many stores will cut boards to size for you.

img 54861 4

Calculation and cutting were simple: the top and bottom pieces were made 1 inch longer than the poster width so the poster would overlap the frame edge slightly and fully cover the wood. The side pieces were cut to account for the added width of the top and bottom pieces so everything fit together snugly.

img 54861 5

I skipped mitered corners for a more rugged, straightforward look. After arranging the boards into rectangles, I clamped them and drove screws through the top and bottom boards into the side pieces. I always pre-drill small pilot holes to prevent the wood from splitting.

img 54861 6

Once assembled, the frames looked nicely substantial. I left the screw heads visible—part of the raw, industrial vibe that works well with bike imagery. If you prefer a cleaner look, you can countersink and fill the holes with wood filler.

img 54861 7

We debated leaving the wood unfinished, but decided a dark stain would better tie the frames to other wood tones in the room. We used a leftover can of Minwax Dark Walnut and finished with a coat of Safecoat polyurethane for protection. Let everything dry thoroughly before moving on—the drying time is the only slow part of the whole project.

img 54861 9

With the frames dry, I laid each poster face-down on the back and centered it. The extra inch on the frame edges hides the poster’s edge so you don’t see any raw paper when the piece is hung. Because our posters were printed on stiff, poster-board-like paper, I attached them by stapling through the poster and into the wood at several points around the perimeter. If your poster paper is thinner, mount it to a firmer board first using a spray adhesive or rubber cement to avoid wrinkles.

img 54861 10

After stapling, I added basic picture-hanging hardware through the poster and into the wood so nothing shows on the front. That kept the look clean and uninterrupted while ensuring the frames hang securely.

img 54861 11

img 54861 12

The outcome is exactly what I hoped for: bold, dimensional artwork that stands off the wall slightly instead of appearing flat. The thick, uncomplicated frame feels intentional and pairs well with the deconstructed bike imagery (the posters are by Public Bikes), while the lack of glass keeps the pieces immediate and tactile. Because the posters are sturdy, we don’t anticipate damage without a protective cover, but glass or plexiglass could always be added later if needed.

img 54861 13

img 54861 14

They make me smile every time I walk into the sunroom, and I especially enjoy catching a glimpse of them from the kitchen sink. We’re planning to add a low, chunky storage piece beneath the artwork to ground the display and balance the scale; I’ll share that update when it’s installed.

img 54861 15

Update: We finally created this Shop Our House page to help you find the furniture and accessories we use, along with our paint colors.