How to Remove Bathroom Wallpaper Without Damaging Walls
Break out the confetti and cue the victory music—our once heavily wallpapered house is finally wallpaper-free. We’ll spare you the twerking, but do allow for a little celebratory dance: after spending more than 45 hours stripping paper from five rooms over the past six months, this bathroom is at last clear of wallpaper and ready for the next stage.
Rather than a dull “we removed the wallpaper” post, we combined that finish with updates on the next steps: how we prepped and patched damaged drywall, primed and painted the trim and quarter-round, and what paint strategy we’ve chosen to balance the room’s bold floor tile with an eye-catching but subtle treatment up high.

To give you a reminder of where we started: the photo above shows the walls primed, which already looks worlds better than the wallpapered surfaces we had been staring at for months.

The peeling process actually began in a funny way: steam from a shower loosened several panels in one corner, so Sherry stripped them off mid-shower and called me in to photograph her triumph. That early steam-assisted success encouraged us to try a clothes steamer elsewhere—my sister’s unit had worked well in the foyer—but this bathroom turned out to be the toughest surface yet.

We experimented with a few approaches, including a 50/50 spray of warm water and fabric softener before steaming, but the paper here refused to come off in big sheets. Instead it peeled in strips and flakes, and a day’s work was required to remove it all.


Unfortunately the walls beneath were rough—worse than in any other room we’d stripped. Years of steam near the shower seemed to have bonded glue and drywall paper in odd ways, leaving a surface we jokingly called “gas station bathroom.”

Because of that condition we moved beyond basic cleanup. First we scrubbed remaining adhesive with warm water and vinegar. Then we sanded the walls with a sanding block to flatten any rough bits. Where the surface had dimples and low points after stripping, we applied thin coats of spackle, scraping them smooth so each fill sat flush with the surrounding wall.


This spot-filling approach took time—we could have applied a full skim coat for a completely smooth wall, but that would have produced a lot more sanding dust and extended the timeline. Small, targeted spackle patches achieved a good balance of effort and results.

Once the spackle dried we sanded again, cleaned up the dust, and watched the walls come back to life. The primer made the biggest visible improvement: it neutralized the yellow tones left behind by the old paper and adhesive and turned the whole space brighter and more even.


While the walls were drying, Sherry decided to paint the trim. The room’s cream trim and wood quarter-round were brought up to date with two coats of Kilz primer (no-VOC) followed by two coats of Simply White semi-gloss trim paint—the same finish we use throughout the house. Taping the floor and working around window panes was tedious, but the result—crisp white trim and painted quarter-round—was worth the effort.


For anyone asking what worked best across all five rooms, here’s a concise recap of our methods and observations:
- Hot water sprayed on the paper, with repeated hand-peeling, worked in the powder room—slow but effective.
- A clothes steamer helped in the foyer and felt slightly faster, though handling high spots can be tiring.
- Warm water and soap applied to the kitchen walls and followed by a wet cloth to loosen the underlayer was tied with the hot-water method for ease and speed.
- Dry-peeling (peeling the top layer dry and using a damp sponge for the backing) worked in the dining room, again a slow process but successful.
- The en-suite bathroom resisted every method—steaming plus a pre-spray of fabric softener helped only a little, and the glue here seemed particularly tenacious, requiring extra sanding and spackling.
In short, the way wallpaper is attached and how well the walls were prepared originally heavily influence removal difficulty. None of our techniques was an instant miracle, but with persistence most methods yielded results over the course of a day or so.
____________________________
With the boring but necessary prep work behind us, we’re moving on to the fun part: a paint treatment designed to balance the bold blue tile floor and visually lift the room. Instead of covering the walls in busy patterns again, we plan to add a simple wood border near the ceiling and paint the top portion of the wall—and the ceiling itself—in a soft, complementary blue. That high-placed color should draw the eye upward, making the room feel taller while letting the floor remain the room’s focal point.

Next steps: paint the primed walls, install and finish the wood trim at the top, and add the accent color above. Once the tall white shower curtain is rehung and we hang art, the transformation should feel complete—and we’ll likely forget the wallpapered room we started with.
Are you tackling a bathroom update, adding painted trim, or removing wallpaper right now? Share your tips for spackling, priming, sanding, or de-wallpapering—other readers will appreciate the advice.
P.S. Sherry is over on Young House Life talking about her maternity-clothing approach.








