How to Frame and Caulk Exterior Doorways
Refinishing the Sunroom Openings: Replacing Metal Frames with Water-Resistant Trim
After removing the sliding glass doors from our sunroom, the most exciting part was over—but it revealed a less glamorous task that couldn’t be ignored. Taking out the metal door frames exposed raw wood around each opening. Not only did it look unfinished, it left the openings vulnerable to moisture and rot. Since preventing water damage was our priority, we tackled this project right away.

When we had the house painted, that room required a lot of exterior rot repair, so we’re especially careful now about exposed wood. Instead of patching the gaps with more wood that could absorb water, I chose PVC trim for most of the pieces. PVC costs a few dollars more per board, but it is far more resistant to moisture and won’t rot the way wood does. For the horizontal pieces at the tops of the door openings—areas unlikely to sit in standing water—I saved money by using pre-primed wood that would accept paint easily.

My boards were 1″ x 6″ x 8′, which turned out to be just a bit wider than the gaps. That meant trimming them down and ripping a small amount off the sides on the table saw. Once I set the fence to the right measurement, the cuts were straightforward and accurate. Taking a little extra care at this stage pays off with a cleaner final fit.

With everything cut to size, I applied construction adhesive to the back of each board and used a nail gun to secure them. It had been a while since I used the nail gun, so it felt good to get back into the rhythm of measuring, fitting and fastening. For the ceiling boards I also added a few screws for extra assurance—adhesive plus nails is solid, but I didn’t want to take any chances with pieces falling later.



Installing all the trim took a couple of hours, and that was followed by several more hours of caulking and finishing. Caulking is one of those detail-oriented tasks that doesn’t look like much in progress, but it’s vital for keeping moisture out and making the installation look finished.

Our main goal was to seal the gaps around the new boards so water can’t make its way behind the trim. While we were at it, we filled other cracks and joints around the room. Caulking not only prevents moisture intrusion but also gives the new frames a cleaner, more finished appearance.

When working at the bottom of the openings, where the trim meets brick, I learned from a previous porch project to use clear silicone caulk instead of white. Brick has an uneven surface that can make a caulk line look messy when the caulk squishes into the mortar and texture. Clear silicone seals effectively but allows the straight edge of the trim to remain the visual border, so the joint reads cleaner. After applying, I smoothed the bead with my finger for a neat finish.

It’s not the most glamorous work, but the transformation is noticeable: the openings now look intentional and protected instead of raw and vulnerable. That peace of mind—knowing the edges are sealed against water—is worth the time and effort.

And judging by this photo, someone is already enjoying the more open, finished space.

Next steps include painting the interior trim—right now the inside of the room is a cream color while the exterior trim is white—so we’ll unify the look with fresh paint. But before we picked up brushes, we couldn’t resist peeking up into the ceiling space and doing a little exploration.

We’ll share more once we finish inspecting and deciding on any ceiling or lofting work. For now, the door openings are protected, the room reads more finished, and the sunroom feels ready for the next phase of improvements.








