How to Remove Wallpaper with Hot Water
The wallpaper in our dining room is finally gone. What a relief—and victory.

There’s something so satisfying about smooth, ready-to-paint walls. The blue trim, on the other hand, is giving my eyes a workout.

Over the years I’ve tested several wallpaper-removal techniques so I could report back on what worked best: boiling water sprayed from a bottle, a wallpaper steamer, and warm water with biodegradable soap applied with a wet rag to lift the backing layer. This time I tried a tip from a former professional painter: start by dry stripping the paper and then follow with wet stripping for the remaining backing.
The dry-stripping approach simply means peeling the top patterned layer by hand without spraying or scoring. In our dining room much of the paper came away in large sheets. There were thinner strips and corners that needed extra attention, but overall it wasn’t painfully slow. Compared to spraying and waiting for the paper to soak, dry stripping felt about the same in total time—and in some ways quicker since you skip the soak-and-wait step. If your walls are drywall that was properly primed before wallpaper was installed, you might have similar luck, especially with older paper that’s already loosening at the seams.

Dry stripping mostly removed the glossy patterned layer, leaving behind a white papered or glued underlayer. To remove that second layer I dunked a large sponge in warm water and wiped the walls to saturate the backing. The moisture usually softened the adhesive and made it possible to peel that underlayer away.


That wet-stripping step is slower—most walls came off in tiny slivers and each wall took roughly an hour and a half to free from the clingy glue film. Still, it was manageable and didn’t require specialized chemicals. The water soak visibly bubbled the backing away from the wall near the sponge, which was a reassuring sign that the adhesive was loosening.


One tricky spot was where the wallpaper was tucked behind the edges of the built-in cabinets. Those seams suggested the built-ins were installed after the wallpaper, so the paper was pinned behind the trim. My solution was to carefully score the edge with an X-Acto knife, running the blade along the trim to cut through the paper. Then I used tweezers to grab and pull the strips away, which gave a clean edge around each built-in.


However, the wallpaper inside two of the built-in bookcases turned out to be a different story. It had been glued directly to unprimed plywood with a very strong adhesive, which made removal nearly impossible. After spending about two hours on a single cubby and ending up with a rough, lumpy surface, we decided to stop trying to strip it back to bare wood.

Instead, we’ll work with the existing paper in those cubbies as the substrate for the finishing method we choose—whether that’s paint, new wallpaper, or fabric adhered over the surface. Removing that glued paper made the surface worse, so leaving it and finishing over it will yield a smoother result.
Despite that small setback inside the built-ins, the main dining room walls are now clean and ready for paint—trim and all. To prepare walls after removing wallpaper, I’ve had good results simply spraying them with a mixture of warm water and vinegar and scrubbing with the rough side of a sponge to remove residual adhesive. There are primers designed to block leftover glue, but our vinegar rinse has worked well enough so far, allowing us to skip specialty primers and save time and money.
As for progress on my pre-baby goals—no more old carpet, no more blue trim, no more dated wallpaper—here’s where we stand:
- de-blue-trim-ify the dining room
de-wallpaper the dining roomfinish Project No More Graph Paper in the kitchen- strip the bold blue master bathroom wallpaper
rip up the old carpet runner on the stairs- paint the blue trim in the office
Slow and steady. We still have another wallpapered room upstairs to tackle, so suggestions are welcome—some people swear by fabric softener, others favor steam. From our experience so far the steamer has been the fastest and easiest when it works, but every method we’ve tried so far has been low-cost and used items we already had or could borrow.
Have you ever battled wallpaper that seemed super-glued to plywood? It’s maddening enough to make you shake your fist at the drywall—trust me, I know the feeling.
Psst—John is over on Young House Life sharing a post about his recent half marathon for anyone who asked about that.









