Prevent Weeds in Paver Patios with Polymeric Sand
Let’s talk about sand in patio joints. We’re always trying to save money where we can, but sometimes being frugal backfires. After living with our finished patio for a few weeks, we ended up wishing we had spent a bit more on the right product from the start.

When we first installed the patio, we used leftover paver sand to fill the gaps between the stones instead of ordering polymeric sand from the stoneyard, which would have cost about $95 for delivery. Regular paver sand is cheaper, but it doesn’t bond or resist erosion as well as polymeric sand, which contains additives that harden when damp and help deter weeds.

At first, the paver sand looked fine in the joints. The stones felt finished and the seams blended well with the patio surface.

However, after a few weeks and several heavy rains, the paver sand started to wash out in many places. The gaps became uneven and the overall appearance looked inconsistent, which was disappointing after all the effort of laying the patio.

So we decided to replace the loose sand with polymeric sand. Rather than paying the initial $95 delivery, we bought a bucket at Lowe’s for about $30. The manufacturer’s estimate suggested one bucket would cover roughly one-third of the patio; because there was still some regular sand packed deep in the joints from the original work, a single bucket ended up stretching farther than expected. In fact, one bucket was enough and we still have extra left for touch-ups.

Applying polymeric sand is a bit tedious. Following the instructions, I used a Ziploc bag with the tip snipped off to pour the sand directly into the joints. It’s a repetitive task, and patience helps ensure even coverage.

The first pass I poured on way too much sand. Once polymeric sand is wetted it really does harden like a cement, so you want to avoid getting it on the face of the pavers. To correct this, I worked in small sections and swept away the excess until the joints were neatly filled without leaving a thick layer on top of the stones.

After sweeping the excess, I used an electric leaf blower on its lowest setting to clear any remaining loose sand from the paver surfaces. The final step was to mist the entire patio with a hose, following the product directions carefully so the sand would activate and bind without washing out.

In hindsight I should have removed a little more loose sand before wetting, which would have left the joints slightly thinner and more refined. That’s one of the lessons learned—right up there with “use polymeric sand from the start.” Even so, the finished result has a relaxed, well-established look rather than a hyper-new appearance.

Although we saved roughly $60 compared to the initial quote, I now appreciate that buying polymeric sand at the beginning would have saved time and produced a more durable finish. The first time I used ordinary paver sand it took several passes to get a decent look; with polymeric sand the process was quicker and the joints set up solidly after just one treatment. Over the coming years, I expect the polymeric sand will perform better at resisting weeds, ants, and erosion.

Here’s a photo I took about a month after applying the polymeric sand. We waited to report back to see how it would hold up through several storms. So far it looks as good as the day we finished it, which is a relief—especially since redoing the joints would have been a lot more work.

Have you had a similar experience—where saving a little up front led to extra work later? Or a project where you wish you’d spent a bit more to do it properly the first time? I’d love to hear your stories so I don’t feel like the only one learning these lessons the hard way.
Psst—Want to follow the whole patio process from start to finish? Here’s the first post (planning), the second post (prepping), the third post (budget surprises), the fourth post (more prep), the fifth post (adding gravel, sand, and most pavers), and the big we’re finally done post with lots of photos.








