Fix Uneven Drywall: How to Spackle for a Smooth Finish
How I Sanded and Touched Up Spackle in the Bathroom
This morning, while Clara was busy with her own project, I took on a small but necessary task in the bathroom: touching up patched drywall. Below are the photos from the day.

I set out to sand and blend a few repaired spots so the wall would look smooth and ready for primer and paint. Here are a couple more shots of the areas I worked on.


A few days earlier I had applied Dap Crackshot spackle to a number of cracks and low spots in the drywall. Even though the big bathroom overhaul looked great overall, we could tell some of the drywall work was our first attempt, so a few seams and imperfections needed a quick fix. Since we’re preparing the house to show, we’re going back through and making all the small repairs that will give a more finished appearance.
Once the spackle was fully dry (always double-check—working with semi-dry filler is a headache), I gathered my tools and got to work. Below is a simple list of what you’ll need for a neat, efficient sanding and touch-up session:
- Dap Crackshot Spackle (or a comparable lightweight spackling compound)
- 100-grit sandpaper or a small sanding block for control
- A flexible putty knife for applying and feathering spackle
- Protective eyewear and a dust mask—optional, but recommended
- Old clothes you don’t mind getting dusty (the less you wear, the less dust you’ll track around—this is optional and personal preference)
Sanding spackle creates a lot of fine dust, so I recommend planning your cleanup strategy before you start. I’ve learned that lighter clothing keeps dust from clinging to fabric and tracking everywhere when you take your clothes off, but the most important step is to keep the dust dry and contained. I prefer to vacuum the dust first rather than wiping with a damp cloth, since wet dust can smear and leave streaks on floors and fixtures.
The actual workflow I used was straightforward:
- Apply spackle with a slightly flexible putty knife, feathering the edges so the patch blends into the surrounding wall.
- Allow the compound to dry completely—often a couple of days for thicker applications.
- Sand lightly with 100-grit paper until the surface feels smooth and level with the wall. Take care not to sand too aggressively and create a divot.
- Vacuum and wipe down the area to remove dust; make sure surfaces and trim are clean before priming.
- Roll primer and then paint over the repaired areas using the same type of roller used on the rest of the room. Matching roller texture helps the patched area blend in better than using a brush, which can show visible brush marks.
Using a roller that matches the original finish makes a surprising difference. A brush can leave different texture and make patched areas obvious, while the same nap and pressure on a roller will help the patched spots disappear into the surrounding surface.
After sanding and cleaning up the dust, I’ll be priming and painting those spots—fingers crossed that the texture and color blend. Small touch-ups like this don’t take long but do a lot to make a room look finished and cared for, which matters when you’re preparing a house to be seen by potential buyers.
On a lighter note, here’s an update on the asparagus plant we picked up at Home Depot a while back. The store folks swore it was hardy, but it hasn’t been thriving in the bathroom environment. You can see how it looks now in the photo below compared to how it started out in an earlier post (originally shared on Young House Love).

Sometimes projects and plants both work out, and sometimes they don’t—so you win some, you lose some (or, in our case, you win some, you kill some). Either way, the bathroom repairs are moving forward and should be ready for a final paint coat soon.








