How to Remove Wallpaper with a Steamer
We tackled the foyer next in our wallpaper removal experiment, testing a clothes steamer to see how it compares to other methods. To recap, we’re working through five rooms using five different removal techniques to determine which works best. Earlier, we tried hot water in a spray bottle and had decent results. This time we borrowed a clothes steamer (John’s sister’s) to put it to the test on the wallpaper in the entryway.

Before we get into the details, a quick farewell to the small blue floral print that had been on these walls.

For the first pass, John steamed a section of wall and I followed behind, pulling the paper off. Overall this approach worked well: most of the paper came off cleanly and in some spots the vinyl and backing separated easily. Some areas left backing that needed to be steamed and peeled again, but the process felt slightly faster than the spray-bottle hot water method — probably about 10% more efficient because more of the backing came off on the first try.
That marginal improvement is worth noting, but only if you factor in the cost of buying or renting a steamer. A clothing steamer or a rented wallpaper steamer can run $20–$50 or more. So unless you plan to use it frequently, the time savings might not justify the expense compared to the free spray-bottle method.
One limitation of the clothing steamer was the hose length when we reached the upper parts of the wall.

The hose wasn’t long enough to let the steamer rest on the floor while we worked the top of the foyer, so John had to hold the hose up as he steamed—think lifting a gallon-size weight for an extended period. If you’re going to invest in a steamer, choose a model made for wallpaper removal rather than a clothes steamer for better hose reach and comfort.
About halfway through, we switched tactics and tried steaming and peeling simultaneously. Instead of steaming a large area and then peeling afterward, I peeled along as John steamed just ahead of me.

This immediate-peel method turned out to be far superior. In most cases it removed both the wallpaper and the backing in one pass, leaving the drywall bare and ready for finishing. The likely reason is that the material stays hotter and more pliable when you peel it right away rather than letting it cool while the steamer moves on to the next section.
Another advantage: one person can do this method. If you’re working alone, you can steam-and-peel as you go and still make good progress.

Compared to the spray-bottle hot water approach, the steam-and-peel method was roughly 30% faster and easier in our larger foyer. That said, larger rooms still take time, and we hit one major complication: layered wallpaper.

We discovered two full layers of the same wallpaper on one entire wall. That meant we essentially had to remove wallpaper twice in the same area, which added time and effort. We don’t know why it was doubled—our best guess is that a previous installer added a second layer to correct a pattern mismatch or coverage issue.
At one point we also had an incident where a stubbornly glued section pulled off the drywall’s surface paper, leaving a damaged patch near the top of the wall.

My plan for that area is to skim-coat with spackle and sand it smooth so it blends with the rest of the wall. It’s a common repair after aggressive wallpaper removal and is straightforward if you have basic drywall patching skills.

Once the wallpaper was down, I cleaned the walls with a spray bottle of half vinegar and half water at room temperature and used the rough side of a sponge to remove any remaining adhesive. Most of the glue came off with the backing, but a few tacky spots smoothed out after this final cleaning step. It’s a quick, inexpensive way to ensure a clean surface for priming or painting.

So that’s our steamer experience in the foyer: effective, especially when you steam and peel immediately, but with a couple of caveats—hose length on clothes steamers, the potential cost of a proper wallpaper steamer, and the extra work if the wall has multiple wallpaper layers or you accidentally damage drywall paper.


Here’s the obligatory before shot from our walkthrough for reference and closure.

Note: the closet and bathroom doors are off in the second-to-last photo because we’re already in the process of painting the blue trim white. We’re about a fifth of the way through that trim job (multiple coats required), and we’ll share the finished photos when the trim is complete.
Have you used a steamer for wallpaper removal? Did you steam an area first and peel afterward, or peel right behind the steamer like we did on our second pass? For us, the steam-and-peel approach, combined with a vinegar-and-water cleanup and occasional patching, turned out to be an efficient way to remove wallpaper and prepare walls for painting.








