How to Program a Garage Door Opener: Step-by-Step
We have two garage doors. I know—sounds mundane—but stick with me: this turned into a satisfying little tech win for anyone who appreciates small conveniences. My partner, Sherry, usually zones out when I start on gadgets, so this one’s for the remote-control crowd and anyone who likes fewer things cluttering the car.

Each door originally came with its own remote from the previous owners. One remote barely worked until a battery swap; then it worked a little too well, sometimes opening or closing the door when it slid around in my cup holder. It didn’t have a visor clip, so the cup holder became its permanent home.

The other remote was more reliable but ugly and oversized—held together with duct tape and too large to store conveniently. Between the two, it was clear we needed a simpler, neater garage door remote solution.

I spotted a Clicker Universal Remote at a store display and decided to simplify to one compact remote. It wasn’t expensive and promised the ability to control both garage doors from a single device—a practical upgrade that would clear up cup holder real estate and eliminate duct tape.

Before diving in, I did a quick Google to understand how these universal remotes work. Many garage door systems use a small row of switches called dip switches inside the opener or remote. The up/down pattern of these switches acts like a fingerprint for your garage opener. Match that pattern in the new universal remote and it will communicate with the opener.
Here’s a photo of the partially obscured dip switch inside one of our existing remotes—just enough to identify the pattern without revealing any sensitive details.

Programming the Clicker meant copying that dip-switch pattern into the new remote. Using the tip of a small screwdriver, I moved each tiny switch to match the up/down sequence. The Clicker’s internal switch bank made it straightforward to replicate the code from the old remotes.


After setting the dip switches, I assigned each button on the Clicker to a door by pressing the desired button until the garage opener responded. It was surprisingly fast—both doors were programmed in roughly ten minutes. Programming the second door didn’t interfere with the first; each button stored its own code independently.

The whole process was easier than I expected. If you’re comfortable with a small screwdriver and following basic instructions, you can probably do this yourself. It’s a practical DIY upgrade: fewer remotes, less clutter, and no more duct-tape repairs.

One extra perk: the Clicker included a visor clip, so I finally mounted the remote in a convenient and secure spot. No more cup-holder shenanigans—just a neat, accessible garage door opener clipped where I can reach it easily while driving.

If you enjoy small tech improvements—especially those that simplify daily routines—this is a worthwhile, low-effort DIY project. We went from two bulky, unreliable remotes to one compact, dependable universal remote that controls both doors. My enthusiasm might have been a little over the top, but getting rid of the duct-tape relics and reclaiming cup-holder space felt like a small victory.
And yes, the YOLO joke gets quoted in our house more often than it probably should. If you’re on the fence about upgrading your garage door remote, give it a try—you might be pleasantly surprised at how quick and easy it is to set up a universal remote and improve your everyday convenience.
In short: one universal garage door remote, simple dip-switch programming, and a tidy visor clip made a small but satisfying improvement to our daily routine. Welcome to a tidier, easier garage door experience.








