Objectales

Popular

How to Remove Old Carpet and Staples

featured 61909

We’ve been juggling a lot of projects around the house lately — from Clara’s room to the master bath, the kitchen, and the veranda — so it’s hard to believe it’s been about a month and a half since we last wrote about the staircase. Many of you asked about the new stair runner we ordered, and after a slight back-order delay it finally arrived. But before we could install it, the last patches of old carpet had to be removed.

img 61909 1

After we removed the carpet from the master bath, the stairs remained the only spot with carpet — although we had already taken off the top step to install the hardwoods back in May. Between putting the job off and worrying about Clara and our small dog navigating slick, uncarpeted steps, we left the remaining carpet in place for months. With the new runner staring at us from its packaging, we finally decided to tackle the job for the puppies’ safety and our own peace of mind.

img 61909 2

Removing the carpet wasn’t technically difficult — just tedious and detail-oriented. Our toolkit was simple and focused on prying things up: a crowbar for lifting carpet, pliers for pulling staples, and screwdrivers for popping stubborn fasteners. Once the crowbar loosened a corner, the carpet came up quickly by hand — gloved hand, since the padding and carpet backing hid scores of staples and other sharp bits.

img 61909 3

Underneath the carpet was where the real work began. The blue foam padding tore up easily, but the staples were another story. There were far more than we expected.

img 61909 4

So many staples, in fact, that we marked them with yellow dots in one photo so you could see how concentrated they were. There were 49 in that single shot. Multiply that by 12 steps and you’re looking at nearly 600 staples and nails to remove — a good reminder of what a small job can turn into once you start pulling up decades of hardware.

img 61909 6

Most staples came up with a flathead screwdriver wedged under one side and then finished with pliers, since often only one side was loose. Some staples broke, some were stubborn and required extra effort, and a few elicited a few colorful words from us. But methodically working step-by-step, we cleaned each tread of metal and adhesive remnants.

img 61909 8

We spread the work across three days, doing a few hours at a time so Sherry could tag-team the job. All told it added up to roughly seven hours. Throughout the process Burger, our dog, kept popping in and out — curious, supportive, and frequently in the middle of our workspace. If there were a montage of the job it would mostly be Burger cameos, stretching, watching, and even sneaking a nose lick when Sherry was concentrated on a tricky staple.

img 61909 10

With the carpet and padding removed, we were left with the stair wood. The condition is generally good — not heavily scratched — but there are some noticeable staple holes in a few areas. Two lower steps showed the most evidence of heavy fastening, suggesting a different tool or method might have been used there. We plan to address these imperfections before installing the runner.

img 61909 12

Our plan includes painting the stair risers white (we won’t paint the treads) to match the look we’ve been aiming for, and using wood filler where needed to hide small holes before painting. The new runner will cover most of the tread holes, and we’ll also use the same refinishing technique we applied to our downstairs floors to minimize the appearance of any remaining scuffs. We’re not changing the color of the treads because they connect with the upstairs flooring, which we matched closely.

img 61909 13

Before the runner goes down we also needed to paint the walls and ceiling along the stairwell to avoid dripping on the new fabric. Painting a high stairwell meant balancing on a ladder with a long roller pole and reaching up as high as 16 feet in places, so it was trickier than it sounds. I used a taped-together brush-and-pole trick to reach upper corners, which made the job manageable. That prep work took about three hours and was worth the effort: having the walls finished will protect the new runner and give the stairwell a clean, cohesive look.

img 61909 14

We used the same Edgecomb Gray paint color we applied in the foyer so the stairwell and upstairs hallway flow visually. For now we painted just enough to prevent worrying about drips on the runner; finishing the upstairs hall will be a separate update since it requires another gallon of paint.

img 61909 15

If all goes well, we’ll share a full runner reveal early next week once the risers are painted and dry. In the meantime, Clara and Burger have navigated the carpet-less stairs without trouble — they don’t feel particularly slick, perhaps from years of wear under the old carpet — but we’re happy to add the runner for added traction and comfort. Anyone else pulling up old carpet and painstakingly plucking out every staple by hand? If so, you know exactly why staples can inspire serious regret.