Objectales

Popular

How to Remove a Rug, Its Pad, and Tack Strips

featured 58235

How We Removed a Stinky Sunroom Rug and Prepped the Concrete Floor

We nicknamed the sunroom rug “Stinky” because the corners were damp from moisture seeping in around the old sliding doors and some rotted wood. The previous owners were aware of the moisture and odor problem, which likely contributed to the lower-than-expected listing price. While the rug was a challenge, it was also an opportunity: we could address an issue that might have put other buyers off and make the house ours.

Here’s the step-by-step on how we removed that rug, the glued-down pad beneath it, and the hidden nails and staples that waited below. First, we used a small crowbar to pry the rug up from the tack strips around the room’s perimeter. These strips were holding the edges in place, so freeing one corner made the rest easier to handle.

img 58235 1

After releasing the edges, we rolled each side toward the center of the room like a scroll. Once both sides met in the middle, we used a box cutter to slice the rug in half so each section would be manageable to carry out. You can cut a rug before rolling it, but we found that rolling first created slack that made the cut easier. Then we carried each section out to the garage while trying not to dwell on how much of our bodies it had touched.

img 58235 2

The next task was the rug pad. Unfortunately it was glued in numerous places instead of simply floating, so we ran into adhesive. For the stubborn, stuck-down sections we used an inexpensive floor scraper (around $25) that we’d also used when removing upstairs carpet. The scraper has a sharp, smooth blade—similar to using a razor to scrape paint off glass—so with firm, even pressure you can slice through the glue and make the concrete surface flush again.

img 58235 3

Even though the glue left stains on the concrete, removing the raised glue bumps made the floor smooth and safe to walk on. While I worked the scraper, John began prying up the tack strips around the room. Those brittle wood strips were full of nails and kept splintering, so they were time-consuming to remove. He had to work a pry bar under them every few inches so they would come up instead of breaking into shards.

img 58235 4

It took us about ten minutes to pull up the carpet, but another hour and a half to remove the glued pad, tack strips, and leftover nails and staples. Once the strips and larger wood shards were out, we picked out the long pieces by hand so they wouldn’t damage the shop vac, then swept up smaller splinters, nails, glue balls, and tufts of old carpet into piles for vacuuming.

img 58235 5

With the debris cleared and the surface scraped smooth, the room already felt dramatically better. The raw concrete—though still marked with glue stains—was far preferable to the swampy, musty carpet we started with.

img 58235 6

The scraper left the floor even and flush. The stubborn glue discoloration had soaked into the concrete, but the raised, rough areas and the collection of nails and staples were gone, which made a big visual and practical difference.

img 58235 7

Our plan from here is to clean the concrete thoroughly, then apply a stain-and-odor-blocking primer to help seal in any remaining smells. After that we’ll use porch and floor paint to conceal the stain marks and protect the surface. Those steps should prevent lingering odors from wafting out on a hot day and make the room about 98% more pleasant to use.

Looking ahead, we have bigger renovation plans for this space. For now Phase 1 focuses on making the room usable and odor-free; later phases include finishing upgrades and structural changes. Our current to-do list includes:

  • Rip up old stinky carpet and padding (completed)
  • Scrub the concrete and seal to prevent lingering odors
  • Stain or paint the concrete floor as a Phase 1 finish*
  • Permanently remove the half-broken baseboard heater
  • Eventually retile the floor with outdoor-safe stone as Phase 2
  • Convert the sunroom into an open, covered porch with new columns and without the worn sliders (many of the sliders and posts are rotten)—we’re using several outdoor porch designs as inspiration
  • Possibly add a brick outdoor fireplace off the sunroom after it’s opened up—different from standard examples but inspired by outdoor fireplace ideas
  • Add beadboard to the ceiling and paint it a soft blue for a classic porch look

*This list is an initial outline. If we learn that a painted floor would complicate future tile work, we’ll adapt the plan and share updates as we go.

We’re relieved to have the old carpet out, even though carrying it to the garage was unpleasant. It was worth the effort to remove the source of dampness and odor and to reveal a surface we can transform. Stay tuned as we clean, seal, and begin Phase 1 of the sunroom refresh.

P.S. Clara is sharing more fun updates elsewhere—one recent item made us laugh until we cried.