How to Remove an Old Bathroom Vanity Backsplash
Happy Friday! We’re painting the foyer today (photos on Monday), but before that I wanted to share two bathroom updates—one minor makeover and one accidental mess that turned out better than expected.
First up: the vanity. That extra slab of countertop on the right side always felt like a bulky “love handle,” so we decided to remove it to create a cleaner look. If your sink has a side-splash or short counter extension you don’t love, this is a straightforward DIY.

How we removed it: we used a manual screwdriver (or a pry bar) pushed under the seam where the side slab met the sink and wall. Tap gently with a rubber mallet or hammer if needed, being careful not to damage the sink top. Work the tool along the seams—top, bottom, or side—until the piece loosens enough to pull off.

We managed to pry the slab off, but the screwdriver left four small punctures in the drywall along the top seam.

Repair steps:
- Sand any loose bits of glue or drywall with a sanding block to create a clean surface.
- Apply spackle with a 2″ putty knife, building slightly above the wall surface so you can sand it smooth later. I use a reliable lightweight spackle—enough to fill and feather the area.
- Let the spackle dry fully (I usually wait about five hours to be safe).
- Sand the dried spackle with a block to keep edges straight and avoid an uneven, wavy finish. Expect some dust—wipe it away before the next step.
- Do a second pass of spackle to fill any low spots or tiny dings that appeared after sanding—this small extra step makes a big difference in a seamless finish.
- After the second coat dries, sand smooth again, wipe clean, then apply paintable silicone caulk between the vanity and wall to seal and protect from water. Smooth the caulk with your finger for a neat bead.
- Finally, touch up the paint so the repaired area blends in seamlessly with the rest of the wall.

Here are the patched areas after the first spackle pass and sanding—then the second pass tightened everything up before the final paint touch-up.

Sealing the joint with paintable white silicone keeps water from running behind the vanity and gives the finish a polished look. Only after the caulk dried did I allow myself to paint—resisting the urge to skip the second spackle sanding is worth it if you want a smooth, professional result.

And now the oops: we spilled about half a quart of the Baby Fern paint we used on the vanity onto the concrete garage floor. It was a gooey mess—panic-worthy at first.

Instead of scrubbing it while wet (which can spread and make a bigger mess), we left it alone to dry into a thick latex blob. After about a week we peeled it up, and surprisingly it virtually came off in one piece. A few small spots needed a second peel, but the main chunk lifted cleanly.

After removing the dried paint mass, there were only a few slightly tinted spots left on the concrete, which faded as the area dried. We moved the items that had been framing the spill and now it’s barely noticeable.

Lesson learned: some paint spills can be best handled by letting them fully cure before attempting removal—especially on concrete. For a big lump of latex paint in the garage, a “wait and peel” approach saved us time and stress.
**********************************
P.S. Here are a few projects and conversations from our community forums if you’d like to browse: four featured threads with DIY topics and before-and-after projects shared by fellow members.
![]() |
![]() |
![]() |
![]() |
![]() |
|||
| by ElizabethAnn | by KatyRICEdesigns | by KellyLawler1 | by ArtisanDesarts |
![]() |














