How to Upholster a Chair Cushion: Step-by-Step Guide
How I Painted and Upholstered My Office Chairs: A Simple DIY Makeover
We finally checked cheerful desk chairs off our office wish list with a quick and inexpensive makeover. This post focuses on the upholstery portion — how I re-covered the seats to match the freshly painted frames and give the whole room a bright, cohesive lift.

Materials and Preparation
I used leftover fabric from our dining room curtains and laid a piece over the detached seat, centering the fabric so the pattern would sit nicely on the cushion. I trimmed the excess fabric, leaving enough around the edges for a firm pull and staple to the underside.

With the fabric properly centered, I flipped the cushion over and added four anchor staples while pulling the fabric tight: one at noon, three o’clock, six o’clock, and nine o’clock. I used a basic manual staple gun — nothing fancy. These first staples keep everything aligned so you can check the front, make adjustments, and avoid having to pull out a lot of staples later.

Stapling and Finishing the Edges
After confirming the pattern looked straight from the front, I flipped the seat back over and added about six staples per side, pulling the fabric taut as I went. The goal is even tension so the cushion looks smooth and tailored from the front.

Corners are handled like wrapping a present — fold the fabric into small triangles at each corner and staple until the front looks neat. The back can look messy, and that’s fine because the front is what matters. Don’t worry about the underside looking imperfect; once flipped and checked, a few more staples will secure everything.

As long as the front is straight and the fabric is pulled tight, you’re golden.

I repeated the same process with the second cushion, lining up the pattern so both seats would match. About 30 staples later, both cushions were done and identical.

Time, Tips, and When to Replace Foam
The entire upholstery portion took roughly 30–45 minutes, depending on how many breaks you take. I was lucky: the original cushion foam and seat bases were in good condition, so I simply covered the existing cushions rather than replacing foam. If your cushions are flat or odorous, you’ll want to remove the fabric and replace the foam — craft stores and fabric shops sell replacement foam by the yard.
After upholstering, I waited for the spray-painted chair frames to fully cure before reattaching the seats. I let them sit in the sun for two days to speed curing and off-gassing, then gave them a third day in the sunroom with a fan to make sure they were ready for everyday use. Finally, I reattached the cushions with the original screws from the seat undersides.

The Finished Look and Design Notes
When I slid the newly dressed cushions onto the freshly painted chairs, the transformation felt almost magical. The greeny-yellow paint and matching fabric pop against the white cabinets and dark wood counters in the office, picking up and enhancing a subtle stencil accent on the wall. The chairs don’t compete with the stencil; instead they layer comfortably together — bold seating against a more subtle background keeps the room balanced.

Because the stencil on the wall is soft and low-contrast, the bold chairs add energy without making the room feel chaotic. The trick is to maintain hierarchy: let one or two elements be the star while others support them in tone and scale.

The best view of the chairs is from the dining room, where they tie in nicely with the table runner. I’m planning to add large-scale art above each chair to provide vertical balance in the office without competing with the chair and stencil combination.

Close-Ups and Before Photos
Here are a few close-ups of the finished seats and a photo of the chairs as we found them at a secondhand shop. They were $35 each, and because I already had fabric on hand, the makeover cost me about $18 for spray paint. If you factor in the original chair price and fabric, the total comes to about $50.50 per chair — a great savings compared to similar new models.



Our office feels a lot happier now, and the process was straightforward: center the fabric, anchor with four starter staples, add even staples around the sides, fold the corners like a present, and reattach once the paint is cured. If you have extra fabric and a couple of hours, you can give secondhand chairs the same fresh, custom look.

Have you reupholstered or painted any chairs recently? If you have extra fabric, this is a fast, affordable way to refresh seating and add personality to a workspace.








