Let’s talk about crack sand. We like to save money wherever possible—sometimes to a fault—and every so often that thriftiness comes back to bite us. After living with our finished patio for a few weeks, we realized we should have spent a bit more on the right product from the start.
If you remember, we used leftover paver sand to fill the joints between the stones instead of paying the stoneyard’s $95 delivery for polymeric sand. Polymeric sand contains binders that act a bit like cement to lock the joints in place and reduce weed growth, so it’s designed to hold up better over time.
At first the ordinary paver sand looked perfectly fine in the gaps.
But after several weeks and a few rains, the sand washed out in many spots. The joints started to look patchy and uneven, and empty gaps made the patio feel unfinished. I was disappointed with how quickly the sand moved around.
So we bit the bullet and bought a bucket of polymeric sand at Lowe’s for about $30. The bag was supposed to cover only a third of the patio, but because there was still some regular sand packed in the bottom of the joints, the polymeric product went much further than expected. One bucket ended up doing the job and left plenty leftover for touch-ups later. While we still didn’t spend the full $95 quoted by the stoneyard, we did learn that the more suitable product would have been worth it up front.
Applying the polymeric sand was tedious. Following the directions, I used a Ziploc bag with the tip snipped off to funnel sand directly into each joint. It’s a slow, repetitive process—there are a lot of cracks to fill—but it’s straightforward.
I initially applied too much sand, which isn’t ideal because once the material gets wet it sets up and becomes cement-like. You want to avoid getting sand on the faces of the pavers where it will harden and be difficult to remove, so it’s important to keep the material only in the joints.
Section by section I swept away the excess until the joints looked neat and the surface of the stones was clean. After filling and sweeping, I went over the whole patio with an electric leaf blower on its lowest setting to remove any remaining sand from the paver faces. Then I misted the area with a hose exactly as the instructions suggested—enough to activate the binder without washing the sand out of the joints.
In hindsight, I should have blown or swept a little more sand off the surface before wetting it so the seams would be slightly thinner and cleaner. That’s a lesson learned, filed right under “Use polymeric sand in the first place.” Even so, the finished look feels pleasantly settled—almost like the patio has been there for a while. When the joints are too clean and bright it reads as brand-new in an awkward way, so the slightly aged look is actually nicer.
Although we saved about $60 compared to the stoneyard quote, I wish we’d chosen polymeric sand during the initial installation. It would have saved time: with the regular paver sand it took me several passes to get an acceptable result, while the polymeric product required only one proper application. More importantly, the polymeric sand should perform better over time at preventing weeds, ant hills, and other nuisances.
Here’s a photo I took about a month after finishing the new sand. We waited to post until we saw how it stood up to a few heavy storms. So far it’s held its place and looks just as good as the day it was installed, which was a relief—I’m not sure I had another reapplication in me if this one hadn’t worked out.
Anyone else learn the hard way and end up redoing something you tried to save on? Or times when you wish you’d spent a little more to get it right the first time? Share your stories—I’d love to hear them so I don’t feel like the only one making these kinds of mistakes.
Psst—If you want to revisit the patio journey from the start, the project posts cover planning, prepping, budget surprises, laying gravel and sand, and the final reveal.